Nikon 10-pin N1 Shutter Interface Switch
This cable was primarily designed as an interface between your camera and StopShot for high speed triggering of your camera but it will also work with StackShot. It will allow StopShot to wake up your camera from sleep mode. The switch also gives a method of quickly disconnecting and connecting StopShot or the RangeIR from your camera, very useful for setting up sensors.
This is a circular 10-pin connector on the camera side.
Cable Length: 3m - 1m Camera Side, 2m RCA side
NOTE: When using the Shutter Switch with StackShot use Sleep position.
Nikon D850, D810./D810A, D800/D800E, D700, D500, D300/D300S, D200, D100 (via MB-D100 battery grip), D5, D4/D4s, D3X, D3, D2H, D2X, D2Xs, D1X, D1H, D1, F100, F90X, F90, F6, F5
Kodak DSC-14n. DSC Pro SLR/n, DSC Pro SLR/c
Fujifilm FinePix S5 Pro, S3 Pro
Shutter Interface Switch
The Shutter Interface Switch was designed as an interface between your camera and StopShot or the RangeIR. It is intended for high speed triggering of your camera but it will also work with StackShot. It is extremely useful for keeping shutter lag to a minimum for Canon users and it will allow StopShot to wake up your camera from sleep mode. It also gives a method of quickly disconnecting and connecting StopShot from your camera, very useful for setting up sensors.
The shutter cable side of this switch is 1 m and the StopShot side is 2 m making the overall length of the switch and cables 3 m long.
The switch has three positions:
WAKE - In this mode the camera will stay awake all the time. It is like holding your finger on the shutter button with it pressed 1/2 way. This position allows for the shortest possible shutter lag. If you are a Canon shooter, it will also make the shutter lag as consistent as Canon shutter lag gets. The disadvantage of this setting is battery life, because the camera stays awake all the time it will also go through batteries faster than the other modes.
OFF - This mode disconnects StopShot from your camera. It will prevent StopShot from triggering your camera, great for setups
SLEEP - In this position the camera will be allowed to go to sleep but unlike our standard sh utter cable with the switch in this position you will be able to wake up the camera with StopShot. This mode is great for shooting mammals overnight where shutter lag is not as important but battery life is. In this mode the camera will have a very long and unpredictable shutter lag.
NOTE: When using the Shutter Interface Switch with StackShot use the SLEEP position on the interface switch.